Panasonic PT-MZ680

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 49
Switching on/off the projector
Connecting the power cord
Make sure that the supplied power cord is securely xed to the <AC IN> terminal of the projector body to
prevent it from being removed easily.
Conrm that the <MAIN POWER> switch is on the <OFF> side before connecting the supplied power cord to the
projector.
Use the power cord matching with the power supply voltage and the shape of the outlet.
For details of power cord handling, refer to “Read this rst!” (
x
page 5).
Note
f
The supplied power cords vary depending on the country or region where you purchased the product.
How to attach the power cord
Fig.1
Fig.2
Fig.3
Fig.4
Power cord holder
1) Confirm that the power cord holder is raised so that the power cord can be inserted. (Fig. 1)
2) Check the shapes of the <AC IN> terminal on the back of the projector and the power cord connector,
then insert the connector completely in the correct direction. (Fig. 2)
3) Lower the power cord holder. (Fig. 3)
4) Press down the power cord holder until the end of the power cord holder snaps onto the power cord
to secure the power cord. (Fig. 4)
f
When pressing down and snapping the power cord holder onto the power cord, hold the power cord from
the opposite side to avoid excessive force to be applied on the <AC IN> terminal.
How to remove the power cord
Fig.1
Fig.2
1) Confirm that the <MAIN POWER> switch on the back of the projector is on the <OFF> side, and
remove the power plug from the outlet.
2) Raise the power cord holder fixing the power cord upward. (Fig. 1)
f
Fix the power cord holder by snapping into the projector.
3) While holding the power cord connector, pull out the power cord from the <AC IN> terminal of the
projector. (Fig. 2)