Panasonic PT-MZ680

Chapter 4 Settings — [PROJECTOR SETUP] menu
118 - ENGLISH
5) Press
qw
to select [OK], and press the <ENTER> button.
f
The lens calibration is started.
f
After completing the calibration, the projection lens will move to the home position.
f
To cancel, select [CANCEL]. In this case, the [LENS TYPE] setting is not changed.
Note
f
The lens shift range varies depending on the lens type. If [LENS TYPE] is set incorrectly, lens shift range may not be adjusted properly. For
details, see "Lens shift range" (
x
page 62).
[LENS CALIBRATION]
Detect the lens shift adjustment limit value, and perform the calibration in the adjustment range.
1) Press
as
to select [LENS].
2) Press the <ENTER> button.
f
The
[LENS]
screen is displayed.
3) Press
as
to select [LENS CALIBRATION].
4) Press the <ENTER> button.
f
The conrmation screen is displayed.
5) Press
qw
to select [OK], and press the <ENTER> button.
f
The lens calibration is started.
f
After completing the calibration, the projection lens will move to the home position.
f
To cancel, select [CANCEL].
Note
f
[PROGRESS] is displayed in the menu during lens calibration. The operation cannot be canceled during calibration.
f
[INCOMPLETE] is displayed when the lens calibration was not executed correctly.
f
The lens shift range varies depending on the lens type. If [LENS TYPE] is set incorrectly, lens shift range may not be adjusted properly. For
details, see "Lens shift range" (
x
page 62).
f
Pressing the <FOCUS> button on the remote control for three seconds or longer will also display the conrmation screen for lens calibration
execution.
[AUDIO SETTING]
Set audio functions in detail.
Adjusting the volume
1) Press
as
to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The
[AUDIO SETTING]
screen is displayed.
3) Press
as
to select [VOLUME].
4) Press
qw
to adjust the level.
Operation Adjustment Range of adjustment
Press
w
. Increases the volume.
0 - 63
Press
q
. Decreases the volume.
Adjusting the left to right audio balance
1) Press
as
to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The
[AUDIO SETTING]
screen is displayed.
3) Press
as
to select [BALANCE].
4) Press
qw
to adjust the level.