Panasonic PT-MZ680

Chapter 7 Appendix — Technical information
192 - ENGLISH
Note
f
The destination of [RS-232C] (
x
page 115) must be set according to the connection method.
f
When connecting using a DIGITAL LINK compatible device, set the [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[STANDBY
MODE] to [NORMAL] to control the projector in the standby mode.
When [STANDBY MODE] is set to [ECO], the projector cannot be control during standby.
Pin assignments and signal names
D-Sub 9-pin (female)
Outside view
Pin No. Signal name Details
(1) (5)
(6) (9)
(1)
― NC
(2)
TXD Transmitted data
(3)
RXD Received data
(4)
MULTI PROJECTOR
SYNC
For contrast synchronization function/for
shutter synchronization function
(5)
GND Earth
(6)
― NC
(7)
CTS
Connected internally
(8)
RTS
(9)
― NC
D-Sub 9-pin (male)
Outside view
Pin No. Signal name Details
(5) (1)
(9) (6)
(1)
― NC
(2)
― NC
(3)
― NC
(4)
MULTI PROJECTOR
SYNC
For contrast synchronization function/for
shutter synchronization function
(5)
GND Earth
(6)
― NC
(7)
RTS
Connected internally
(8)
CTS
(9)
― NC
RS-232C communication conditions (factory default)
Signal level
RS-232C-compliant
Sync. method
Asynchronous
Baud rate
9 600 bps
Parity
None
Character length
8 bits
Stop bit
1 bit
X parameter
None
S parameter
None
Basic format
Transmission from the computer starts with STX, then the ID, command, parameter, and ETX are sent in this
order. Add parameters according to the details of control.