Panasonic PT-RZ31K - Page 125

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 125
Setting [SYSTEM SELECTOR] in [SDI IN]
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [SINGLE LINK SETTING] or [DUAL LINK SETTING], and press the <ENTER>
button.
f The [SINGLE LINK SETTING] or [DUAL LINK SETTING] screen is displayed.
f When [DUAL LINK SETTING] is selected, proceed to Step 5).
4) Press as to select [SDI1] or [SDI2], and press the <ENTER> button.
f The [SINGLE LINK SETTING] or [DUAL LINK SETTING] screen of the selected item is displayed.
5) Press as to select [SYSTEM SELECTOR].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Automatically selects [RGB], [YP
B
P
R
4:4:4], [YP
B
P
R
4:2:2], or [XYZ].
[RGB], [YP
B
P
R
4:4:4], [YP
B
P
R
4:2:2], or [XYZ] is automatically selected by reading the payload ID
attached to the input signal. [RGB] is selected when the payload ID is not attached to the input signal.
[RGB] Fixes to [RGB].
[YP
B
P
R
4:4:4] Fixes to [YP
B
P
R
4:4:4].
[YP
B
P
R
4:2:2] Fixes to [YP
B
P
R
4:2:2].
[XYZ] Fixes to [XYZ].
Setting [BIT DEPTH] in [SDI IN]
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [SINGLE LINK SETTING] or [DUAL LINK SETTING], and press the <ENTER>
button.
f The [SINGLE LINK SETTING] or [DUAL LINK SETTING] screen is displayed.
f When [DUAL LINK SETTING] is selected, proceed to Step 5).
4) Press as to select [SDI1] or [SDI2], and press the <ENTER> button.
f The [SINGLE LINK SETTING] or [DUAL LINK SETTING] screen of the selected item is displayed.
5) Press as to select [BIT DEPTH].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Automatically select [12-bit] or [10-bit].
[12-bit] Fixes to [12-bit].
[10-bit] Fixes to [10-bit].
Setting [SIGNAL LEVEL] in [SDI IN]
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [SINGLE LINK SETTING] or [DUAL LINK SETTING], and press the <ENTER>
button.
f The [SINGLE LINK SETTING] or [DUAL LINK SETTING] screen is displayed.
f When [DUAL LINK SETTING] is selected, proceed to Step 5).