Panasonic PT-RZ31K

Chapter 7 Appendix — Technical information
ENGLISH - 215
r COLOR, TINT
Performance Parameter Default value
No operation 0-31
0
Factory default setting 32-63
- 31 64-65
… …
0 128-129
… …
+31 190-191
No operation 192-255
r RASTER PATTERN
Performance Parameter Default value
No operation 0-15
0
OFF 16-31
WHITE 32-47
YELLOW 48-63
CYAN 64-79
GREEN 80-95
MAGENTA 96-111
RED 112-127
BLUE 128-143
BLACK 144-159
USER LOGO 160-175
No operation 176-255
r ENABLE/DISABLE
Operation for all channels is not accepted when set to “Disable”.
Performance Parameter Default value
Disable 0-127
0
Enable 128-255
Note
f If the projector is operated using the remote control or the control panel, or by the control command while controlling the projector using the
Art-Net function, the setting of the DMX controller or computer application may be different from the projector status. To reect the controls
of all channels to the projector, set “ENABLE/DISABLE” of channel 11 to “Disable” and then back to “Enable”.
f To create/register the USER LOGO image, use “Logo Transfer Software” included in the supplied CD-ROM.
Control commands via LAN
When web control administrator rights password is set (Protect mode)
Connecting
1) Obtain the IP address and port number (Initial set value = 1024) of the projector and request a
connection to the projector.
f You can obtain both the IP address and the port number from the menu screen of the projector.
IP address
Obtain from the [NETWORK] menu → [NETWORK STATUS].
Port number
Obtain from the [NETWORK] menu → [NETWORK CONTROL] → [COMMAND PORT].
2) Check the response from the projector.