Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 67
Making adjustments and selections
It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
1) 8)
5)
6)
3)
7) 9)
3)
2)
4)
1) 5) 7) 8) 9)2)
6)
1) Press the <FOCUS> button to roughly adjust the focus of the projected image. (x page 70)
2) Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 35)
f Refer to “Navigating through the menu” (x page 81) for the operation of the menu screen.
3) Press the input selection button (<RGB1>, <RGB2>, <DIGITAL LINK>, <DVI-D>, <HDMI>, <SDI>, <SDI
1/2>) to select the input signal.
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 47)
5) Press the <SHIFT> button to adjust the position of the projected image.
6)
If the input signal is the analog RGB signal or the DVI-D/HDMI signal, press the <AUTO SETUP>
button.
7) Press the <ZOOM> button to match the projected image size to the screen.
8) Press the <FOCUS> button again to adjust the focus.
9) Press the <ZOOM> button again to adjust the zoom and match the projected image size to the screen.
Note
f When the projector is switched on for the rst time after purchase, as well as when the [PROJECTOR SETUP] menu → [INITIALIZE] →
[ALL USER DATA] is executed, the focus adjustment screen is displayed after projection starts, and then the [INITIAL SETTING] screen is
displayed. Refer to “When the initial setting screen is displayed” (x page 61) for details.
To Next Page
Loading...
