Panasonic PT-RZ31K

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 157
[REGISTERED SIGNAL]
Deletes all the setting values saved for each input signal.
To delete only a part of a registered signal, perform the procedure described in “Deleting the
registered signal” (x page 161).
[NETWORK/E-MAIL] Returns [NETWORK SETUP] and [E-mail set up] to factory default settings.
[LOGO IMAGE] Deletes the image registered in [USER LOGO].
5) Press the <ENTER> button.
6) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f The following settings are not initialized even if [ALL USER DATA] is executed.
g The [DISPLAY OPTION] menu → [UNIFORMITY]
g The [PROJECTOR SETUP] menu → [OPERATION SETTING] → [OPERATING MODE]
g The [PROJECTOR SETUP] menu → [OPERATION SETTING] → [MAX LIGHT OUTPUT LEVEL]
g The [PROJECTOR SETUP] menu → [STANDBY MODE]
g [FILTER TYPE] and [FILTER COUNTER] in the [PROJECTOR SETUP] menu → [FILTER SETTING]
g Security password
[SERVICE PASSWORD]
This function is used by a service person.