Panasonic PT-RZ31K

Chapter 2 Getting Started — Attaching/removing the projection lens (optional)
48 - ENGLISH
Attaching/removing the projection lens (optional)
Move the lens position to the home position before replacing or removing the projection lens. (x page 72)
Attention
f Replace the projection lens after turning off the power of the projector.
f Do not touch the electric contacts of the projection lens. Dust or dirt may cause poor contact.
f Do not touch the surface of the projection lens with your bare hands.
f Before attaching the projection lens, remove the lens cover attached to the projection lens.
f Panasonic takes no responsibility for any damage or malfunction of the product resulting from the use of projection lenses which are not
manufactured by Panasonic. Be sure to use the specied projection lenses.
Note
f The precautions for handling the lens are different for the Fixed-focus Lens (Model No.: ET-D75LE95). For details, refer to the Operating
Instructions of ET-D75LE95.
Attaching the projection lens
Attach the projection lens using the following procedure. Start from Step 3) when the lens hole cover is already
removed.
Mark (orange)
Fig. 3 Fig. 4
Fig. 1 Fig. 2
Screw hole A
Lens fixing screw
Screw
Lens hole cover
Lens release button
1) Loosen the screw fixing the lens hole cover. (Fig. 1)
f Use a Phillips screwdriver to turn the screw xing the lens hole cover counterclockwise until it turns freely.