Panasonic PT-TX320

ENGLISH - 105
Mode
Display resolution
(dots)
Scanning frequency
Dot clock
frequency
(MHz)
Format*
1
PnP *
2
H (kHz) V (Hz)
Computer 1/
Computer 2
HDMI
1280 x 960 1 280 x 960 60.0 60.0 108.0 R/H
l l
SXGA
1 280 x 1 024 64.0 60.0 108.0 R/H
l l
1 280 x 1 024 80.0 75.0 135.0 R/H
l l
1 280 x 1 024 91.1 85.0 157.5 R/H -- --
1366 x 768
1 366 x 768 39.6 49.9 69.0 R/H -- --
1 366 x 768 47.7 59.8 85.5 R/H -- --
1400 x 1050
1 400 x 1 050 65.3 60.0 121.8 R/H -- --
1 400 x 1 050 82.3 74.9 156.0 R/H -- --
1440 x 900 1 440 x 900 55.9 59.9 106.5 R/H -- --
1600 x 900
1 600 x 900 55.9 60.0 119.0 R/H -- --
1 600 x 900*
4
60.0 60.0 108.0 R/H
l l
UXGA 1 600 x 1 200 75.0 60.0 162.0 R/H
l l
1680 x 1050 1 680 x 1 050 65.3 60.0 146.3 R/H -- --
1920 x 1080 1 920 x 1 080*
4
66.6 59.9 138.5 R/H -- --
WUXGA 1 920 x 1 200*
4
74.0 60.0 154.0 R/H -- --
*1 <COMPUTER 2 IN> terminal is only for RGB signals input.
*2 Where marked "l" signals indicates in Plug and Play is compatible with EDID of projector. Unmarked signals in Plug and
Play may also be compliant if input terminals are written in the format list. Where Plug and Play is unmarked and nothing is
written in the format list, difculties in projecting image may occur even when computer and projector appear to have same
resolution.
*3 Pixel-Repetition signal (dot clock frequency 27.0 MHz) only.
*4 VESA CVT-RB (Reduced Blanking)-compliant.
Note
f The number of display dots is 1 280 x 800 for the PT-TW350 and 1 024 x 768 for the PT-TX410 and PT-TX320.
A signal with a different resolution will be projected after converting the resolution to match the projector display.
f “i” added to the resolution value indicates an interlaced signal.
f When interlaced signals are connected, icker may occur on the projected image.
f The image may not be displayed in full screen according to the computer output setting.
Chapter 7 - Appendix - Technical Information