Panasonic PT-TX320 - [Security]

ENGLISH - 65
4) Press the <ENTER> button.
f The [Logo PIN code] input screen is displayed.
5) Press the <ENTER> button.
6) Enter the Logo PIN code you have set according to the steps in "Enter a Logo PIN code".
r Enter a Logo PIN code
i) Press as to select a number from 0 to 9.
ii) Press the <ENTER> button.
f The xed number change to , the cursor move to the next digit.
iii) Repeat the above steps, and enter a three-digit number.
f Move the cursor to [Set] after xing the three-digit number.
iv) Press the <ENTER> button.
f Return to the [Logo] screen.
7) Press as to switch the item.
f The items will switch each time you press the button.
[On]
Set or change [Logo select] and [Capture] are disabled without entering the PIN code.
[Off]
Set or change [Logo select] and [Capture] are enabled without the PIN code.
Attention
f The initial Logo PIN code is "111".
f Change the Logo PIN code periodically that is hard to guess.
Note
f If you want to correct the digit, press the <MENU> button to reset the digit and then re-enter it.
f Press the <ENTER> button after moving the cursor to [Cancel] to return the menu screen.
f If you entered an incorrect digit, the digit () will turn red and reset, and then re-enter a digit.
[Logo PIN code change]
Change the Logo PIN code.
1) Press as to select [Logo].
2) Press the <ENTER> button.
f The [Logo] screen is displayed.
3) Press as to select [Logo PIN code change].
4) Press the <ENTER> button.
f The [Logo PIN code] input screen is displayed.
5) Press the <ENTER> button.
6) Press as to enter the current Logo PIN code from 0 to 9 and press the <ENTER> button.
7) Press the <ENTER> button.
f The [New logo PIN code] input screen is displayed.
8) Enter the new Logo PIN code according to the steps in "Enter a Logo PIN code".
Note
f If you want to correct the digit, press as to reset the digit and then press as re-enter it.
f Press the <ENTER> button after moving the cursor to [Cancel] to return the menu screen.
f If you entered an incorrect digit, the digit () will turn red and reset, and then re-enter a digit.
[Security]
Set the PIN code to prevent the unauthorized operation by the third party. The [PIN code] input screen will be displayed when
turn on the projector.
1) Press as to select [Security].
2) Press the <ENTER> button.
f The [Security] screen is displayed.
Chapter 4 - Settings - [Expand] menu