ENGLISH - 55
[Setting] menu
On the menu screen, select [Setting] from the main menu, and select an item from the sub-menu.
Refer to “Navigating through the menu” (x page 44) for the operation of the menu screen.
fAfter selecting the item, press as to set.
MEMORY VIEWER/
USB DISPLAY
ASPECT
INFO.
IMAGE
LAMP
DAYLIGHT
VIEW
COMPUTER 1
COMPUTER 2
VIDEO
ENTER
MENU
KEYSTONE
FREEZE
AV MUTE
P-TIMER
D.ZOOM
VOLUME
MUTE
[On start]
Set the method of start up when the power cord plugged into the AC outlet.
1) Press as to select [On start].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Off]
Starts up in the standby mode.
[On]
Starts the projection immediately.
Note
f When you do not turn off the projector in procedure of “Powering Off the Projector” (x page 36), the On start function will
not work properly.
[Standby mode]
Set the power consumption during standby. Change the setting whether or not use the network function.
1) Press as to select [Standby mode].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Eco]
Restricts some functions in the standby mode to reduce power consumption.
[Normal]
Does not restrict network function and serial communication function even in the standby mode.
Note
f If [Standby mode] is set to [Eco], you cannot use network functions and some RS-232C commands.
[High land]
Change the setting according to the altitude in which you use the projector.
1) Press as to select [High land].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Off]
When using the projector in the elevation of below 1 400 m (4 593').
[On 1]
When using the projector in the elevation of above 1 400 m (4 593') and below 2 700 m (8 858').
[On 2]
When using the projector in the elevation of above 2 700 m (8 858') and below 3 000 m (9 843').
Chapter 4 - Settings - [Setting] menu
To Next Page
Loading...
