56 - ENGLISH
Note
f It is set to [Off] when using the projector in the elevation of below 1 400 m (4 593'). It is set to [On 1] when using the projector
in the elevation of above 1 400 m (4 593') and below 2 700 m (8 858'). It is set to [On 2] when using the projector in the
elevation of above 2 700 m (8 858') and below 3 000 m (9 843'). Failure to do so may shorten the life of the internal parts
and result in malfunctions.
f Do not set the projector in the elevation of 3 000 m (9 843') or above, otherwise it may shorten the life of the internal parts
and result in malfunctions.
f When it is set to [On 1] or [On 2], the fan noise becomes louder and fan speed increases.
[Lamp control]
Switch the brightness of the lamp according to the operating environment of the projector or the purpose.
1) Press as to select [Lamp control].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
f You can also press the <LAMP> button on the remote control. (x page 40)
[ (Normal)]
Select when high luminance is required.
[ (Eco 1)]
Select when high luminance is not required.
[ (Eco 2)] Select when lower luminance than [ (Eco 1)] is required.
Note
f Set it to [ (Eco 2)] rather than [ (Eco 1)], set it to [ (Eco 1)] rather than [ (Normal)], when you want to reduce
power consumption, extend the life of lamp and reduce operation noise.
[Cooling fast]
Switch the cooling fan' speed when the power is turned off and shorten the cooling time of the cooling fan.
1) Press as to select [Cooling fast].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Normal]
Use this setting normally.
[60 Sec]
Use this setting when short cooling period of time is required.
[0 Sec]
The cooling fans stop immediately after power-off.
Note
f When it is set to [0 Sec], you cannot restart the projector immediately after the power-off. The lamp remains high
temperature and needs to be cooled, so it sometimes takes longer time than usual for the lamp to light up again.
f When it is set to [60 Sec], the cooling fans' speed is faster and the motor noise is louder than [Normal] setting after the
power-off.
[Closed caption]
(Only for NTSC input)
Set the closed caption.
1) Press as to select [Closed caption].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Off]
Closed caption is not displayed.
[CC1]
Displays CC1 data.
[CC2]
Displays CC2 data.
[CC3]
Displays CC3 data.
[CC4]
Displays CC4 data.
Chapter 4 - Settings - [Setting] menu
To Next Page
Loading...
