Panasonic PT-TX320 - Page 64

64 - ENGLISH
3) Press as to switch the item.
f The items will switch each time you press the button.
[Logo select]
Set the logo display when the projector start-up.
[Capture]
The projected image is captured as a still image. The captured image will be displayed as the
startup logo when [Logo select] is set to [User].
[Logo PIN code
lock]
Set and change the Logo PIN code, and prevents an unauthorized person from changing the PIN
code.
[Logo PIN code
change]
Change the [Logo PIN code].
[Logo select]
Set the logo display when the projector start-up.
1) Press as to select [Logo].
2) Press the <ENTER> button.
f The [Logo] screen is displayed.
3) Press as to select [Logo select].
4) Press the <ENTER> button.
5) Press as to switch the item.
f The items will switch each time you press the button.
[Off]
Displays only the countdown to project when the projector start-up.
[Default]
Displays the Panasonic logo and the countdown when the projector start-up.
[User]
*1
Displays the image registered by the user with the capture function.
*1 [User] will be unavailable when the captured image is not registered.
[Capture]
Set the user logo display when the projector start-up.
1) Press as to select [Logo].
2) Press the <ENTER> button.
f The [Logo] screen is displayed.
3) Press as to select [Capture].
4) Press the <ENTER> button.
5) A confirmation screen is displayed, press as to select [Yes] and then press the <ENTER> button.
f After capturing the image, the [Logo select] is set to [User]. The captured image will be displayed when the projector
start-up next time.
Note
f Only supports still image-based computer (RGB) and still image-based HDMI signals input.
f Capture may not be available depending on the input signal.
f It is recommended to capture the same resolution signal as the display dots (panel resolution) of the projector.
For PT-TW350 : 1 280 x 800
For PT-TX410, PT-TX320 : 1 024 x 768
f [Capture] and [Logo select] will be unavailable when [Logo PIN code lock] is set to [On].
f The adjustments of the [Keystone] will be canceled temporarily when the image is capturing.
[Logo PIN code lock]
Set the Logo PIN code (three-digit).
1) Press as to select [Logo].
2) Press the <ENTER> button.
f The [Logo] screen is displayed.
3) Press as to select [Logo PIN code lock].
Chapter 4 - Settings - [Expand] menu