Panasonic PT-VW435NU

Basic operations by using the remote control
40
- ENGLISH
Basic Operation
Switching the input signal
You can switch the input signals to project.
Buttons
Press (<COMPUTER 1>, <COMPUTER
2>, <HDMI>, <VIDEO>, <S-VIDEO>, or
<NETWORK>) button on the remote
control.
COMPUTER 1
Switch to Computer 1(RGB)/
Computer 1(Component)/
Computer 1(Scart) input.
COMPUTER 2
Switches to Computer 2(RGB)
input.
HDMI Switches to HDMI input.
VIDEO Switches to Video input.
S-VIDEO Switches to S-video input.
NETWORK Switches to Network input.
Note
Each press of the <INPUT> button on the Control Panel
z
of the main unit switches the settings as shown below.
(
Æ
page 24)
Computer 1 (RGB)/
Computer 1 (Scart)/
Computer 1 (Component)
Computer 2
(RGB)
HDMI
Network S-video Video
It depends on the item you selected in the
[Computer 1] submenu of the [Input] menu.
Using the MUTE button
Press this button on the remote control to select [On]
to temporarily turn off the sound.
Button
Press <MUTE> button on the remote
control.
Note
To turn the sound back on, press this button again or
z
press the <VOL -/+> buttons. (
Æ
page 57)
Using the D.ZOOM +/- buttons
This function allows you to enter to the Digital zoom
+/– mode.
Buttons
Press <D.ZOOM +/-> buttons on the
remote control.
Note
For details, see "Screen" of Main menu. (
z
Æ
page 55)
Using the FREEZE function
You can freeze the projected image and stop the
sound temporarily, regardless of the playing condition
of the connected device.
Button
Press the <FREEZE> button on the remote control to
freeze the picture on the screen, meanwhile, volume
is muted. To cancel the Freeze function, press the
<FREEZE> button again or press any other button.
Fig.1 will appear on the screen while the Freeze
function is working.
Fig.1
Note
When no signal inputs,
z
mark will appear.
*
*