Network
ENGLISH -
75
Settings
Connecting with Wired LAN
Projector settings
J
Use the LAN cable (Straight) to connect the projector with computer.1 )
Turn on the projector and press the <MENU> button on the remote control.2 )
Press the menu button to open the [Network] menu, and then select [Wired LAN], 3 )
and press <ENTER> button.
Set the detailed setup of [Wired LAN].4 )
For details, see “Wired LAN” (
Æ
page 67).
Note
Please conrm with your network administrator before you connect to an existing network.
z
The following settings are set before the projector leaves the factory.
z
Computer operation
J
Connection can be made with wired LAN. However, conrm to your system administrator on network settings
before changing any settings.
Turn on the computer.1 )
Make the network setting according to your system administrator.2 )
If the projector settings are the default settings (Æpage 67), the computer can be used with the following
network settings.
IP address 19 2.16 8.10.101
Subnet mask 255.255.255.0
Default gateway 192.16 8.10.1
Connecting with Wireless LAN
Projector settings
J
Turn on the projector and press the <MENU> button on the remote control.1 )
Press the menu button to open the [Network] menu, and then select [M-DIRECT], or 2 )
[USER 1] ~ [USER 3] for [WIRELESS LAN] and press <ENTER> button.
According to the network number selected in step 2, set the detailed setup of 3 )
[Wireless detailed setup].
For details, see “Wireless detailed setup” (
Æ
page 68-71).
DHCP
OFF
IP Address 192.168.10.10 0
Subnet Mask 255.255.255.0
Default gateway 192 .168.10.1
DNS 1/DNS 2 NONE
To Next Page
Loading...
