Network
76
- ENGLISH
Settings
Note
Wireless LAN and wired LAN cannot be used in the same segment.
z
When multiple devices are connected, a unique IP address must be allocated to each device.
z
SSID has to be entered in alphanumeric letters.
z
You cannot set “any” or “ANY” for SSID.
z
The following settings are set before the projector leaves the factory.
z
Computer operation
J
Make the network setting according to your system administrator.1 )
If you select [M-DIRECT] for [Wireless LAN] in the network menu, the IP address will automatically be
acquired.
If you select default settings of [USER 1] ~ [USER 3] for [Wireless LAN] in the network menu
(Æpage 71), then the computer can be used with the following network settings.
IP address 19 2.16 8.11.101
Subnet mask 255.255.255.0
Default gateway 192.16 8.11.1
Click [Start]→[Connect To 2 )
]→[Wireless Network Connection
], select the wireless
network of [SSID] set with the projector, and then click [Connect
].
When you select default settings of [M-DIRECT] for [Wireless LAN] in the network menu, the SSID is
[M-DIRECT + The last 4 digits].
When you select default settings of [USER 1] ~[USER 3] for [Wireless LAN] in the network menu, the
SSID is [Panasonic Projector].
The names are for Windows XP. In Windows Vista/Windows 7, the procedure will be [Start]→[Connect To]. The names
may differ depending on the Operation System. Please connect the network according to the displayed names on your
computer.
Note
If you use any wireless utility other than Windows [Wireless Network Connection], follow its operation
z
procedure for connection.
If you use the access point, congure the computer and each network setting of the projector following the
z
instruction of the network administrator.
DHCP OFF
IP address 192.16 8.11.10 0
Subnet mask 255.255.255.0
Default gateway 192.16 8.11.1
SSID Panasonic Projector
Mode AD HOC
Authentication OPEN
Encryption NONE
Channel 11
IP Address
192.168.12.100
Subnet Mask 255.255.255.0
SSID
M-DIRECT + The last 4 digits
of the projector ID
Channel 1
Key The same string as the SSID
[M-DIRECT] [USER1] ~ [USER3]
To Next Page
Loading...
