EasyManua.ls Logo

Panasonic PT-VW435NU

Panasonic PT-VW435NU
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH -
95
Maintenance
Replacement
Before replacing the unit
When you perform maintenance or replacement of the parts, make sure to turn off the power and disconnect
z
the power plug from the wall outlet. (
Æ
page 32, 36)
Be sure to observe the procedure “Turing off the projector” (
z
Æ
page 36) when performing power supply
operation.
Maintenance
Outer Case
J
Wipe off dirt and dust using a soft dry cloth.
If the dirt is persistent, soak the cloth with water and wring it thoroughly before wiping. Dry off the projector
z
with a dry cloth.
Do not use benzene, thinner, or rubbing alcohol, other solvents, household cleaners. Using them may
z
cause deterioration of the outer case.
When using chemical treated dusters, follow its instruction.
z
Front glass surface of the lens
J
Wipe off the dirt and dust off the front surface of the lens with soft clean cloth.
Do not use a cloth that has an abrasive surface or a cloth that is moist, oily, or covered with dust.
z
Do not use excessive force when wiping the lens as it is fragile.
z
Attention
The lens is made of glass. Impacts or excessive force when wiping may scratch its surface.
z
Please handle with care.
Replacing the unit
The air lter units are provided in side and back of the projector.
Replacement of the air lter unit (side)
J
Remove the air lter cover.1 )
Open the air lter cover in the direction of the
z
arrow in the gure and remove it.
Remove the air lter unit.2 )
i) Hold the knob of the air lter unit and pull out in
the direction of the arrow, the top of the air lter
unit will pop up.
ii) Take out the air lter unit upwards.
After removing the air lter unit, remove large
z
foreign objects and dust from the air lter
compartment and the projector’s air intake port
if there are any.
Insert the new air lter unit.3 )
Hold the air lter unit that the knob is outside of
z
the projector, perform Step 2) in the reverse order.
Do not press the lter part when push into the
z
projector at last.
Install the air lter cover.4 )
Make sure that the air lter cover is closed tightly.
z
Air filter cover (side)
Knob
Air filter unit (side)

Table of Contents

Related product manuals