Panasonic PT-VW435NU

Network
ENGLISH -
93
Settings
Termination of memory viewer
J
To terminate the memory viewer function, take one of methods described below.
 Terminate with projector’s on-screen menu.
1. Select “Wired” or “Wireless” from the input menu of the projector. Press <ENTER> button.
2. Select “Memory Viewer” with the point ▲▼ buttons and press <ENTER> button. The “Enter/Exit” pallet of
the memory viewer appears.
3. Select “Exit” and press <ENTER> button.
 Terminate with memory viewer mode
1. During the image displaying, press <AUTO SETUP/CANCEL> button. The browser window appears on
the screen.
2. Press <AUTO SETUP/CANCEL> button again. The cursor moves to menu item.
3. Select “Exit” on the browser window with the point ◄► buttons and press <ENTER> button.
 Terminate with plugged out the USB thumb directly.
Formatting the USB thumb drive
J
A new USB thumb drive or a USB thumb drive formatted by computer or camera must be formatted by
this product. Memory Viewer function may not operate properly with a USB thumb drive formatted by
other equipment.
1. In the memory viewer mode, press <AUTO SETUP/CANCEL> button. The browser window appears on
the screen.
2. Press <AUTO SETUP/CANCEL> button again. The cursor moves to menu item.
3. Select “Format” from “Set” with the point buttons and press <ENTER> button. The format conrmation
window appears.
4. Select “OK” with the ◄► buttons and press <ENTER> button to start formatting. It takes about 1-2
seconds to complete the formatting.
Note
 Formatting the USB thumb drive may delete all the stored data, please backup the data you need before
formatting.
 During formatting the USB thumb drive, do not turn off the power or eject the USB thumb drive because the
data in the USB thumb drive might get damaged. During formatting, the USB thumb drive is blinking.