Network
ENGLISH -
71
Settings
Set [EAP], [USER NAME],
and [PASSWORD].
EAP
1
: Select the EAP
setup in the
RADIUS server
1
. Types of
EAP that can be
selected are as
follows.
PEAP
1
(MS-
CHAPv2
1
),
PEAP
1
(GTC
1
),
EAP-TTLS
1
(MD5
1
),
EAP-TTLS
1
(MS-CHAPv2
1
), EAP-FAST
1
(MS-CHAPv2
1
), EAP-FAST
1
(GTC
1
)
USER
NAME:
Input a user
name used for
authentication
(excluding
spaces)
(maximum 64
characters).
PASS
WORD:
Input a
password
used for
authentication
(maximum 64
characters).
1: “Glossary” (
Æ
page 117 – 118)
Note
If you are unable to connect to the wireless LAN
z
through the access point even after performing the
steps in “Projector settings (
Æ
page 76)”, contact the
manufacturer of the access point.
When using EAP, the projector needs to be set according
z
to the setting of the RADIUS server. Check with the
network administrator for the setting of the RADIUS
server.
When using an EAP together with an access point with
z
invalid SSID broadcast, select WAP-EAP or WAP2-EAP
for the authentication method even if the authentication
method of the access point is WPA-EAP/WPA2-EAP.
Default settings of [USER 1] - [USER 3]
The following settings as [USER1] - [USER3] in the
wireless LAN are set before the projector leaves the
factory.
SSID Panasonic Projector
DHCP Off
IP address 192.168.11.10 0
Subnet mask 255.255.255.0
Default gateway 19 2.16 8.11.1
Mode AD HOC
Authentication OPEN
Encryption NONE
Channel 11
DNS 1/DNS 2 NONE
Press ▲▼◄► to select [Set], and press 5 )
<ENTER> button.
Save the current network settings
Note
When conguration is completed, you need to select [Set]
z
and press the <ENTER> button. At this point, select [Back]
to go back to the previous screen (2/3), or select [Cancel]
to cancel the conguration change.
Sending image from iPad / iPhone /
iPod touch
By using the dedicated application, you can send the
PDF le or the JPEG image which stored on your iPad
/ iPhone / iPod touch to the projector for projecting.
For details, please enter the following URL.
http://panasonic.net/avc/projector/
Projector name
You can change the projector name to be displayed
on the network.
Press ▲▼ to select [Projector name], 1 )
and press <ENTER> button.
Select characters with the ▲▼◄► 2 )
buttons and press the <ENTER>
button to enter the projector name.
Select [BS] to delete one character selected
with the cursor in the input box and press the
<ENTER> button.
Select [Set] with the ▲▼◄► buttons 3 )
and press the <ENTER> button.
Select [Cancel] to undo the changes and then
press the <ENTER> button.
Select [YES] or [No] with the ▲▼ 4 )
buttons and press the <ENTER>
button.
Note
[Name
z
□□□□
] (
□□□□
is four-digit number) is set
before the projector leaves the factory.
To Next Page
Loading...
