Network connection
This projector has network function that allows the following by connecting a computer.
f WEB control
By accessing the projector from a computer, you can perform setting, adjustment, status display, etc. of the
projector. Refer to “Web control function” (x page 94) for details.
f Multi Monitoring & Control Software
“Multi Monitoring & Control Software” is used to monitor and control multiple display devices (projector or at
panel display) connected via LAN.
Refer to the Operating Instructions of the “Multi Monitoring & Control Software” in the supplied CD-ROM for
details.
f Early Warning Software
“Early Warning Software” is used to monitor the status of the display devices (projector or at panel display) or
the peripheral device within the intranet, and to notify the problem or to detect the sign of possible problem of
the device.
Visit the Panasonic website (https://panasonic.net/cns/projector/pass/) for details.
f PJLink
Operation or status query of the projector can be performed from a computer with the PJLink protocol. Refer to
“PJLink protocol” (x page 119) for details.
f Command control
Operation or status query of the projector can be performed from a computer with the control commands. Refer
to “Control commands via LAN” (x page 120) for details.
Connecting via wired LAN
Example of a network connection
Computer
LAN cable
(straight)
LAN cable (straight)
Hub
Projector
Attention
f When a LAN cable is directly connected to the projector, cabling must be made indoors.
Note
f A LAN cable is required to use the wired LAN function.
f Use a straight or crossover LAN cable that is compatible with CAT5 or higher. Either the straight or the crossover cable, or both cables
can be used depending on the system conguration, check with your network administrator. The projector identies the type of the cable
(straight or crossover) automatically.
f Use a LAN cable of 100 m (328'1") or shorter.
Projector settings
1) Connect the projector to a computer using a LAN cable.
2) Turn on the power of the projector.
3) Select the [NETWORK] menu → [WIRED LAN] from the main menu and press the <ENTER> button.
92 - ENGLISH
Chapter 5 Operation of Function - Network connection
To Next Page
Loading...
