Panasonic PT-VZ580

Making adjustments and selections
It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
3)
5) 9) 6)1) 8)
4) 4)
3)
7)
7)
1) Roughly adjust the focus of the image with the focus lever. (Æ page 45)
2) Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (
Æ
page 29)
f Refer to “Navigating through the menu” (
Æ
page 53) for the operation of the menu screen.
3) Press the input selection buttons on the remote control or the <INPUT SELECT> button on the control
panel to select the input signal. (
Æ
page 44)
f The buttons that can be used on the remote control are as follows.
<COMPUTER 1> button, <COMPUTER 2> button, <VIDEO> button, <HDMI 1> button, and <HDMI 2>
button
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (Æ page 46)
5) Adjust the size of the image to match the screen with the zoom lever.
6) Adjust the vertical projection position with the vertical lens shift dial.
7) If the input signal is an analog RGB signal, press the <AUTO SETUP> button.
8) Adjust the focus again with the focus lever.
9) Adjust the size of the image to match the screen with the zoom lever again.
Note
f When the projector is switched on for the rst time after purchase or the [PROJECTOR SETUP] menu → [INITIALIZE ALL] is executed, the
[INITIAL SETTING] screen is displayed after projection starts. Refer to “When the initial setting screen is displayed” (
Æ
page 40).
Switching off the projector
2)
1)3)
2)
1)
1) Press the power <v/b> button.
f The [POWER OFF] conrmation screen is displayed.
42 - ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector