14
6.5. Disassembly of Battery P.C.B.
• Refer to “Disassembly of Rear Cabinet Block”.
Step 1 : Release the catch.
Step 2 : Release the 2P Cable from the slot.
Caution : During assembling, ensure that the 2P cable is
properly inserted into the slot.
Step 3 : Slightly press the Battery P.C.B. by using screwdriver.
Step 4 : Remove the Battery P.C.B..
Caution : During assembling, inserted the 2P Cable into
the opening of Rear Cabinet Block as diagram shown.
Ensure the Battery P.C.B. is seated properly into the slots.
To Next Page
Loading...
