Error
Code
Diagnosis
Contents
Description of error Automatic FL Display Remarks
POWER
AMP
output
abnormal
During normal
operation, if DCDET
becomes "L",
normal POWER OFF
process shall not be
executed, PCONT
shall be switched to
"L" immediately.
"GOODBYE" shall
not be display but
the error display
F61 is displayed
instead. 2 seconds
after the F61
displayed, ECONO
shall be set to "L"
and FL display shall
be turned off. The
error content shall
be memorized when
the abnormality
occurs and can be
display in the C-
mecha self-
diagnostic mode
described later.
For Power Supply Related
Error Detection.
Press [
on main unit for next error.
9. Assembling and Disassembling
9.1. Caution
“ATTENTION SERVICER”
Some chassis components may be have sharp edges. Be careful when disassembling and servicing.
1. This section describes procedures for checking the operation of the
major printed circuit boards and replacing the main components.
2. For reassembly after operation checks or replacement, reverse the
respective procedures. / Special reassembly procedures are described
only when required.
3. Select items from the following index when checks or replacement are
required.
Warning:
This product uses a laser diode. Refer to “Precaution of Laser Diode”.
ACHTUNG:
32
To Next Page
Loading...
