29
RQT8552
Before use
Adjusting the bass
• You can adjust the bass
through this operation.
1
Select and confirm the choice.
2 Make adjustment and confirm the
choice.
Adjustment range:
-
10 dB to +10 dB
Factory setting: 0 dB
Adjusting the treble
• You can adjust the treble
through this operation.
1 Select and confirm the choice.
2
Make adjustment and confirm the choice.
Adjustment range:
-
10 dB to +10 dB
Factory setting: 0 dB
Adjusting the volume
balance
• You can adjust the balance
of the front speakers.
1 Select and confirm the choice.
2
Make adjustment and confirm the choice.
The bar shows the standard balance.
You cannot adjust volume balance when you use
SFC’s “PARTY ” mode (á page 25).
L : Front left R : Front right
Changing the audio
output (Dual program)
• The unit allows you to
switch dual audio signals in
Dolby Digital and DTS
formats.
The sign “DUAL PRG
” appears on the display
when the unit receives a dual audio signal.
1 Select and confirm the choice.
2
Select audio and confirm the choice.
MAIN : Main audio output (Factory setting)
SAP : Sub channel audio output
M+S : Main and sub channel audio output
Adjusting the
brightness of the
display
• Dim the display for better
viewing in a darkened room.
1 Select and confirm the choice.
2
Select a setting and confirm the choice.
• Select “OFF ” to cancel.
Adjustment range:
DIMMER 1 (bright) to DIMMER 3 (dim)
Factory setting: OFF
Sleep timer
• The sleep timer can turn the
unit off after a set time.
1 Select and confirm the choice.
2 Select the time and confirm the
choice.
• When this is set, “SLEEP” appears on the display.
• To check the setting:
After setting the time, you can check the
remaining time using step 1.
• To change a setting:
Repeat the procedure from the beginning.
Times available for setting:
30, 60, 90, 120 (minutes)
Factory setting: OFF
It does not control any other components.
Note
Note
Sound effect/Convenient functions
ENGLISH
To Next Page
Loading...
