EasyManua.ls Logo

Panasonic SA-XR57 - Help Messages and Specifications; Understanding Help Messages; Technical Specifications

Panasonic SA-XR57
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38
RQT8552
Help message
Specifications (DIN 45 500)
n AMPLIFIER SECTION
Power output (at AC 230-240 V)
DIN 1 kHz (T.H.D. 1 %) 2 x 100 W (6 )
20 Hz-20 kHz continuous power output both channel driven
2 x 80 W (6 )
Total harmonic distortion
rated power at 20 Hz-20 kHz 0.09 % (6 )
Power bandwidth
both channel driven, –3 dB 4 Hz to 88 kHz (6 Ω, 0.9 %)
Power output each channel driven (at AC 230-240 V)
DIN 1 kHz (T.H.D. 1 %)
Front (L/R) 100 W (6 )
Center 100 W (6 )
Surround (L/R) 100 W (6 )
Surround Back (L/R) 100 W (6 )
Load impedance
Front (L/R)
A or B 6 to 16
A and B 6 to 16
BI-WIRE 6 to 16
Center 6 to 16
Surround (L/R) 6 to 16
Surround Back (L/R) 6 to 16
Frequency response
CD, DVD, DVD Recorder, VCR, TV/STB, AUX
4 Hz to 88 kHz, ±3 dB
DVD 6CH 4 Hz to 44 kHz, ±3 dB
Input sensitivity and impedance
CD, DVD/DVD 6CH, DVD Recorder, VCR, TV/STB, AUX 200 mV/22 k
S/N at rated power (6 )
CD, TV/STB, DVD, DVD Recorder (Digital input)
90 dB (IHF, A: 103 dB)
Tone controls
BASS 50 Hz, +10 to –10 dB
TREBLE 20 kHz, +10 to –10 dB
Channel balance (250 Hz-6.3 kHz) ±1 dB
Channel separation 55 dB
Subwoofer frequency response (–6 dB) 7 Hz to 200 Hz
n FM TUNER SECTION
Frequency range 87.50 to 108.00 MHz
Sensitivity
S/N 30 dB 1.5 µV/75
S/N 26 dB 1.3 µV/75
S/N 20 dB 1.2 µV/75
IHF usable sensitivity (IHF ’58) 1.5 µV/75
IHF 46 dB stereo quieting sensitivity 22 µV/75
Total harmonic distortion
MONO 0.2 %
STEREO 0.3 %
S/N
MONO 60 dB
STEREO 58 dB
Frequency response 20 Hz to 15 kHz, +1 dB, –2 dB
Alternate channel selectivity ±400 kHz, 65 dB
Capture ratio 1.5 dB
Image rejection at 98 MHz 40 dB
IF rejection at 98 MHz 70 dB
Spurious response rejection at 98 MHz 70 dB
AM suppression 50 dB
Stereo separation 40 dB
Carrier leak 19 kHz, –30 dB
38 kHz, –50 dB
Channel balance (250 Hz-6.3 kHz) ±1.5 dB
Limiting point 1.2 µV
Bandwidth
IF amplifier 180 kHz
FM demodulator 1000 kHz
Antenna terminal 75 (unbalanced)
n AM TUNER SECTION
Frequency range 522 to 1611 kHz (9 kHz steps)
530 to 1620 kHz (10 kHz steps)
Sensitivity 20 µV, 330 µV/m
Selectivity (at 999 kHz) 55 dB
IF rejection (at 999 kHz) 50 dB
n VIDEO SECTION
Output voltage at 1 V input (unbalanced) 1±0.1 Vp-p
Maximum input voltage 1.5 Vp-p
Input/output impedance 75 (unbalanced)
S-Video Input DVD, DVD Recorder, TV/STB
Output TV MONITOR
Component Video Input DVD Recorder, TV/STB
Output TV MONITOR
n GENERAL
Power supply AC 230 to 240 V, 50 Hz
Power consumption 140 W
Dimensions (W x H x D) 430 mm x 107.5 mm x 390 mm
Mass 4.7 kg
Notes:
1. Specifications are subject to change without notice.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum analyzer.
Message Cause/countermeasure
1
Muting is on.
Press [MUTING] on the remote
control and cancel the function
(á page 27).
2
The selected mode is not “
MUSIC
”.
Change the mode to “MUSIC
(á page 24).
3
Center and surround speakers are
not connected, or they are set as
absent. Connect the speakers
(á page 11) or change their setting
to present (á page 31).
4
Surround and surround back
speakers are not connected, or
they are set as absent. Connect
the speakers (á page 11) or
change their setting to present
(á page 31).
5
Surround back speakers are not
connected, or they are set as
absent. Connect the speakers
(á page 11) or change their setting
to present (á page 31).
Message Cause/countermeasure
6
You are trying to use the effect
unavailable for DTS-ES sources.
7
You are trying to use the effect
unavailable for DVD-Audio
sources.
8
You are trying to use the effect
unavailable for DVD analogue 6-
channel playback.
9
You are trying to use the effect
unavailable for the current input
source.
10
(flashing)
The unit is in thePCM FIX ” mode.
Cancel this mode (á page 32).
11
SPEAKERS A is off. Press
[SPEAKERS A] to turn on
“SPEAKERS A” (á page 16).
12
SPEAKERS A and SPEAKERS B
are off. Select one of the speakers
(á page 16).
Digital input (Optical) 2
(Coaxial) 2
HDMI (Version 1.2a) Input 1
Output 1
Power consumption in standby mode: 0.9 W
Power consumption in HDMI off Mode: 0.35 W
Help message/Specifications
ENGLISH

Table of Contents

Related product manuals