36
10.8. Replacement of iPod Block
• Refer to “Disassembly of Base Stand Assembly”
• Refer to “Disassembly of Door Assembly”
• Refer to “Disassembly of Front Ornament Unit”
• Refer to “Disassembly of Front Panel Block”
10.8.1. Disassembly of iPod Block
Step 1 : Slightly lift up & remove the Slide Guide Pin as shown.
Step 2 : Detach 5P wire at the connector (CN501) on the iPod
P. C.B . .
Step 3 : Push the iPod Block forward until it come to a stop.
Step 4 : Slightly lift up the iPod Block from Stopper area as
shown and push forward again.
To Next Page
Loading...
