46
Caution : During assembling, ensure the Remote Sensor
P.C.B. is seated properly and fully catched.
Step 6 : Detach 5P cable at the connector (P945) on the
Remote Sensor P.C.B..
Step 7 : Remove the Remote Sensor P.C.B..
10.11. Replacement of Gear Box
Assembly
• Refer to “Disassembly of Base Stand Assembly”
• Refer to “Disassembly of Door Assembly”
• Refer to “Disassembly of Front Ornament Unit”
• Refer to “Disassembly of Front Panel Block”
• Refer to “Disassembly of iPod Block”
10.11.1. Disassembly of Gear Box Assem-
bly
Step 1 : Remove 2 screws.
Step 2 : Release the 4P Wire from the slot.
Step 3 : Detach 4P wire at the connector (CN931) on the Motor
P. C. B ..
Caution : During assembling, ensure the 4P wire is
dressed into the slot.
To Next Page
Loading...
