74
10.31. Disassembly of Passive Radia-
tor (SP3 & SP4)
Note : Passive Radiator (SP3 & SP4) have the same mechani-
cal structure. For disassembling of Passive Radiator (SP4),
repeat the (Step 1) to (step 2) of 10.31..
Below illustrated Passive Radiator (SP3)
• Refer to “Disassembly of Base Stand Assembly”
• Refer to “Disassembly of Door Assembly”
• Refer to “Disassembly of Front Ornament Unit”
Step 1 : Remove 2 screws.
Step 2 : Remove the Passive Radiator (SP3).
10.32. Disassembly of Front Speaker
(SP1)
• Refer to “Disassembly of Base Stand Assembly”
• Refer to “Disassembly of Door Assembly”
• Refer to “Disassembly of Front Ornament Unit”
• Refer to “Disassembly of Front Panel Block”
• Refer to (Step 1) - (Step 3) of item 10.24.
• Refer to “Disassembly of CD Mechanism”
Step 1 : Detach 2P wire at the connector (CN401) on the Main
P. C. B ..
Step 2 : Release the 2P wire from the slots.
Caution : During assembling, dressed the 2P wire into the
slots as shown.
To Next Page
Loading...
