Operations
RQT9772
25
∫ Remote control code
When other Panasonic devices respond to this
system’s remote control, change the remote control
code on this system and the remote control.
Preparation
≥ Turn off all other Panasonic products.
≥ Turn on the main unit.
Change the remote control code to code 2:
1 Aim the remote control at the main unit’s
remote control sensor.
2 Press and hold [MUTE] and [ ] on the
remote control for more than 4 sec.
≥ All the indicators will blink for 10 sec when the
code of this system is changed.
≥ The setting is maintained until it is changed again.
≥ If the main unit does not operate after changing the code,
repeat steps 1 and 2.
≥ To change the remote control code to code 1, repeat the
steps above, but replace [ ] with [INPUT SELECTOR].
∫
To reduce the clear-mode dialog effect
When the dialog does not sound natural while the
volume is set low, it is possible to reduce the
dialog enhancing effect as follows:
While pressing and holding [SOUND] on the
remote control, press and hold [s VOL] on the
main unit for more than 4 sec.
≥ All the indicators will blink once when the clear-mode
dialog effect is reduced.
≥ Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
To reset the setting, return to the factory preset. (> 26)
∫
To turn off VIERA Link “HDAVI Control”
When “HDAVI Control” compatible equipment
does not work well with this system, for example,
it is possible to turn off this function as follows:
≥ When VIERA Link is turned off, the ARC
function is not available. Be sure to connect the
optical digital audio cable. (> 16)
1 While pressing and holding [MUTE] on the
remote control, press and hold [s VOL] on
the main unit for more than 4 sec.
2 After the setting has changed, turn off all the
connected devices and then turn them on again.
≥ All the indicators will blink once when VIERA Link “HDAVI
Control” is turned off.
To reset the setting, return to the factory preset. (> 26)
∫ To turn off the volume limitation
If a state of the lowered volume disturbs you
every time the main unit turns on, for example, it
is possible to turn off this function as follows:
While pressing and holding [MUTE] on the
remote control, press and hold [VOL i] on the
main unit for more than 4 sec.
≥ All the indicators will blink once when the volume limitation
is turned off.
To reset the setting, return to the factory preset. (> 26)
Others
SC-HTB170EGEBGN_RQT9772-B.book 25 ページ ２０１３年２月４日 月曜日 午前９時５分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
