Panasonic SC-HTB170 - Step 2: Placement; Rack or Table Placement

Getting started
Precautions
RQT9772
11
Step 2 Placement
Supplied accessories
Additionally required accessories (commercially available)
≥Fall prevention cord ..................................................................................................................... k 2
≥Screw eyes (to attach the fall prevention cord)............................................................................. k 2

≥ Use commercially available screws that are capable of supporting over 33 kg.
≥ Use a cord that is capable of supporting over 33 kg (with a diameter of about 1.5 mm).
Attach the cord to the main unit.
When placing the main unit
in a rack or on a table
≥ Place the main unit on a flat and horizontal surface.
∏ 2 Basic stands ∏ 2 30
o
stands
∏ 2 80
o
stands ∏ 2 Screws with washer
A Cord*
* If the cord cannot be threaded through the holes, try bending the cord in 2 locations,
about 5 mm apart from the tip, at an angle of 45
o
(as illustrated above).


SC-HTB170EGEBGN_RQT9772-B.book 11 ページ ２０１３年２月４日 月曜日 午前９時５分