EasyManua.ls Logo

Panasonic SF4C Series - Page 20

Panasonic SF4C Series
143 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Before Using this Device
SF4C Safety light curtain
12
Emitter
Function Description
Operation
indicator
[OSSD]
(green/red),
(Note 3)
Lights up when the sensor operation is as follows (OSSD 1/2):
When the control output (OSSD 1/2) is ON: lights up green.
When the control output (OSSD 1/2) is OFF: lights up red.
Digital error
indicator (red)
When the safety light curtain is in the lockout state, the error contents are
displayed here.
Fault indicator
[FAULT]
(yellow)
When a fault occurs in the sensor: lights up or blinks.
PNP indicator
[PNP] (orange)
When the PNP output is set: lights up
NPN indicator
[NPN] (orange)
When the NPN output is set: lights up
Test input
indicator [TEST]
(orange)
Lights up when test input is active.
Turns OFF when test input is inactive.
Safety input 1
indicator [S1]
(orange)
Lights up when safety input 1 is active.
Turns OFF when safety input 1 is inactive.
Safety input 2
indicator [S2]
(orange)
Lights up when the safety input 2 is active.
Turns OFF when the safety input 2 is inactive.
The description given in [ ] is marked on the sensor.
Receiver
Function Description
Large
multi-purpose
indicator
(Note 1)
Lights up in red when the large multi-purpose indicator input is active.
Lights up in green when the large multi-purpose indicator input is active.
Turns OFF when the input is inactive.
Incident light
intensity
indicator (green
/orange) [STB]
Lights up in green when stable light is received.
Lights up in orange when unstable light is received.
Turns OFF when light is blocked. (Note 2)
A
When the control output (OSSD 1/2) is ON: lights up green.
When the top block receives light: lights up red.
When the top end receives light: blinks red.
B
When the control output (OSSD 1/2) is ON: lights up green.
When the upper middle block receives light: lights up red.
Beam-axis
alignment
indicator
(green/red)
[RECEPTION]
C
When the control output (OSSD 1/2) is ON: lights up green.
When the lower middle block receives light: lights up red.
Rugghölzli 2
CH - 5453 Busslingen
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
mailbox@sentronic.com
www.sentronic.com
Produkte, Support und Service
SEN
TRONIC
AG

Table of Contents

Other manuals for Panasonic SF4C Series

Related product manuals