6.1. Remove the Back cover
1. See Service Hint (Section 5)
6.2. Remove the fan
1. Disconnect the relay couplers.
2. Remove the screws (×3
each) and remove the fans.
6.3. Remove the rear terminal
cover
1. Remove the screws (×8 ,×5 ,×2 ).
2. Remove the rear terminal cover.
6.4. Remove the P-Board
Caution:
To remove P.C.B. wait 1 minute after power was off for
discharge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable.
2. Disconnect the couplers (P2, P5, P9, P10, P11, P12, P23,
and P25).
3. Remove the screws (×7
) and remove the P-Board.
6 Plasma panel replacement method
9
TH-37PX60U / TH-42PX60U
To Next Page
Loading...
