6.20. Removal of the Plasma Panel
1. Disconnect the Fan Relay connectors.
2. Remove each 3 screws (
) and then remove the 2 Fan
Blocks.
3. Remove each 4 screws (
) and then remove the Stand
Black(L, R).
4. Remove each 1 screws (
) and then remove the Speaker
Terminal Block(L, R).
5. Disconnect the connectors (DS1, DS2, DS4, DS6, DS7,
DS8, DS14, DS15).
6. Remove 4 screws and then remove the Slot Block.
7. Disconnect the connectors (DN6, DN31, DN33, DN35).
8. Remove the Flexible Cable from the connector (DN1).
9. Remove 4 screws and then remove the DN-Board Block.
10. Disconnect the connectors (P2, P6, P7, P9, P11, P12,
P25).
11. Remove 6 screws (
) and then remove the P-Board.
12. Disconnect the connectors (D5, D25).
13. Remove the Flexible Cable from the connectors(D20, D31,
D32).
14. Remove 4 screws and then remove the D-Board.
15. Remove the Flexible Cable from the connectors (SU1, SU2,
SU3, SU4, SD1, SD2, SD3, SD4).
16. Remove 6 screws.
17. Disconnect the connectors (SU45, SD46).
18. Slide the SU-Board and the SD-Board to the left, remove
the SU-Board and the SD-Board from the connectors
(SC41, SC42).
15
TH-50PH10UK
To Next Page