42
VL-SVN511BX/VL-SVN511CX/VL-SVN511CX1
9.2.5. Installation of the lead wires
When assembling the door station, route the lead wires as shown in the figure below, and be careful that they do not get caught.
9.2.6. Item to be checked after completion of assembly (camera lens angle adjustment)
After completing assembly work, move the angle adjustment lever on the rear surface in the left and right directions, and confirm
that it moves all the way.
Note:
When the camera angle is adjusted to the upper left and upper right, the image may be slightly distorted.
To Next Page
Loading...
