• Default: Off
Note
• When “Off” is selected for “Super Dynamic(SD)”, the interactive control with face detection is
deactivated.
[Adaptive black stretch]
Select “On” or “Off” to determine whether or not to activate the darkness compensation function. The darkness
compensation function can make darker parts of images brighter by digital image processing.
*When “On” is selected for “Super Dynamic(SD)”, this setting is unavailable.
• On: Activates the darkness compensation function.
• Off: Deactivates the darkness compensation function.
• Default: Off
IMPORTANT
• When “On” is selected for “Adaptive black stretch”, noise in the darker parts may be increased, and
parts around borders between the darker parts and the brighter parts may become darker/brighter than
the other darker/brighter parts.
[Back light compensation (BLC)]
Select “On” or “Off” to determine whether or not to activate the back light compensation (BLC) function.
*When “On” is selected for “Super Dynamic(SD)”, this setting is unavailable.
The back light compensation function can compensate back light by setting mask areas on brighter parts of
images brighter.
• On: Mask areas will be set automatically.
• Off: Mask areas will not be set automatically. It is necessary to set them manually.
• Default: Off
[Mask area]
When “Off” is selected for “Super Dynamic(SD)”
and “Back light compensation (BLC)”, it is
possible to compensate for backlight by masking brighter areas.
Refer to page 76 for information on how to set the mask area.
[Light control mode]
Select the light control mode from the following.
• Indoor scene (50 Hz) / Indoor scene (60 Hz): The shutter speed will automatically be adjusted to prevent
flicker caused by fluorescent light. Select 50 Hz or 60 Hz corresponding to the location where the camera
is in use.
• ELC(Maximum exposure time): The lighting control will be automatically performed by adjusting shutter
speed in the range of ELC.
ELC(1/30s)/ ELC(3/100s)/ ELC(3/120s)/ ELC(2/100s)/ ELC(2/120s)/ ELC(1/100s)/ ELC(1/120s)/
ELC(1/250s)/ ELC(1/500s)/ ELC(1/1000s)/ ELC(1/2000s)/ ELC(1/4000s)/ ELC(1/8000s)
• Default: ELC(1/30s)
Note
• The shorter the maximum exposure time is, the more accurately it is possible to capture a fast moving
object with less blur.
• When a faster shutter speed is selected, the sensitivity will become lower.
• When a faster shutter speed is selected, flickering may happen.
In case flickering happens, it may be improved by configuring the following settings.
In the area of 50 Hz power supply frequency:
– ELC(3/100s), ELC(2/100s), ELC(1/100s)
Operating Instructions 73
11 Configure the settings relating to images [Image]
To Next Page
Loading...
