USER MANUAL
short sound signal and LED indicator will light green. If the learning procedure finishes
with an error, LED indicator will light red and a siren will emit four sound signals.
Saving changes:
To finish the learning procedure, switch off the ignition and press VALET button. The
system will return to programming mode.
Level 18 – Registering and unregistering mobile device
The system supports only one mobile device. Registration of a new mobile device
(if the system has previously registered device) is not allowed without deleting
procedure. When you overwrite the same device in the system memory, you should
delete the Bluetooth connection on your mobile device, delete the mobile device
from the system memory and then register the mobile device in the system memory.
To register a mobile device, enter the programming mode and press VALET button
18 times. LED indicator will light green (green light indicates the system is ready to
register a mobile device) and the system will enter the mobile device registration
mode. Red light of LED indicates the system has already had registered mobile device,
overwriting of mobile device can be done only after deleting procedure.
Mobile device registration:
• LED indicator will light green after entering the level. Open the mobile application
and press «Search device» button. The application will search for the system via
Bluetooth connection. Select the found system, the system and the mobile device
will be automatically paired. The system will confirm the pairing with a sound signal
of a siren and red flash of LED indicator.
Deleting mobile device:
LED indicator will light red after entering the level. Press VALET button and hold
P R O G R A M M I N G T H E S Y S T E M
WARNING! If there is no automatic pairing, enable «PIN request for
phone pairing» in the «Radio tag and mobile device functions» settings.
Then perform the registering mobile device procedure again. The PIN will be
required to pair the devices (0-0-1-1-1-1)