PANDORA LIGHT PRO SERVICESECURITY SYSTEM
it for more than 4 seconds, release the button. The system will confirm deleting with
the series of sound signals of the siren and the system will return to mobile device
registration mode (LED indicator will light green).
Saving changes:
To finish the registration of a mobile device, VALET button should be pressed once,
the series of red and green flashes of the status LED indicator will confirm the saving,
switch on the ignition to save the settings and exit the programming mode.
Level 19, 20, 21, 22, 25, 26 – Updating firmware of additional devices
Download the firmware from www.tssgroup.sk and install Pandora BT application on
your mobile device.
To update firmware of additional devices, enter the programming mode and
press VALET button the number of times equals to the desired level number (see the
Programming levels table). Find your system in the mobile application, go to detected
devices and upload the previously downloaded firmware to the system.
Level 23, 24 Recording door sensors №1, №2 (DMS-100 BT)
Door sensors recording is performed one by one starting from the 23 level: A door
sensor№1isrecordedonthe23level;adoorsensor№2isrecordedonthe24level.A
door sensor can be overwritten only on the level of its initial registration.
To record door sensors №1, №2, enter programming mode and press VALET button
23 times for the door sensor №1 or 24 times for the door sensor №2. LED indicator will
light green and the system will enter the recording of a door sensor mode. Insert the
battery into the sensor. The system will confirm recording witha short sound signal.
Saving changes:
To finish the recording of the Bluetooth radio relay, press VALET button once, the
series of red and green flashes of the status LED indicatorwill confirm the saving, switch
on the ignition to save the settings and exit the programming mode.
P R O G R A M M I N G T H E S Y S T E M
To Next Page
Loading...
Need help?
General
