Panduit TDP43ME - Page 55

TDP43ME
TDP43ME: PA26305A01_08 Page 55 of 75 11-2022
The internal circuitry has now been set to Ethernet port active.
The printer must now print something
for the Custom Command to take
effect.
In the TDP43ME window, click on the
printer to be tested.
Click Print a test page
The printer will print the test page. The
printer was previously set to switch
Ethernet port to active at the end of the
next print command sent. After the test
page is printed, the relay within the
printer will switch to activate the
ETHERNET port. [A slight audible click
may be heard when the relay switches
from one port to the other port.] If the
printer red-lights, that is ok, simply turn
off the printer and then turn it back on.
The note below Panduit TDP43ME will
indicate if the printer is OFFLINE.
If printer is OFFLINE.
Click on Panduit TDP43ME