TDP43ME
TDP43ME: PA26305A01_08 Page 57 of 75 11-2022
Double click the NPS Control Center
icon to start the software.
Remove the label covering the
Ethernet port on the printer.
Insert an Ethernet cable into the
network connector.
Open the CONTROL CENTER
SOFTWARE and write down the NetPS
address that appears when the
software opens.
(Ethernet cable must be connected
to the printer).
NOTE:
If no address is shown next to NetPS,
then the Ethernet cable is not active,
the Ethernet cable is not plugged in or
active or DHCP is not providing an IP
address. A number/address must
appear next to NetPS. If any of the
above conditions occurred, the Control
Center Software may need to be
restarted.
If an IP address appears next to NetPS,
write this number down. If no Static IP
address is to be used, continue to Step 3.
A simple check to see which port is active
is as follows:
Click on the IP address to highlight it.
The information will appear in the lower
status box. Below the Printer model line
is the LAN interface status line. If the line
displays DISCONNECTION, the USB port
is active. If the line displays HIGH
SPEED, the Ethernet port is active.
To Next Page
Loading...
