6 Reference & Installation Manual
source’s data. If you want to program more than one
keypad with the source’s data, enter the serial numbers
of the keypads one at a time.
6. Once you have entered the serial numbers of the
keypads you want to program, press the [
ACC] key.
3.4 Memory Key
Sections [510] and [520]
Download information to and from an LCD keypad using the
memory key (PMC-3).
Only the PMC-3 memory key will function with the
LCD keypad.
3.5 Download Contents of Memory Key to Keypad
Section [510]
1. Insert the memory key into the keypad’s connector
labelled “
KEY” (refer to Figure 2.1 on page 3).
2. To download the contents of the memory key, enter the
keypad’s programming mode and enter section [510].
3. When the keypad emits a confirmation beep, wait 5
seconds and remove the memory key after the second
confirmation beep.
Section [510] = Download all from the memory key (LCD
keypad sections [001] to [396] and all
messages) to the LCD keypad.
Section [520] = Copy the LCD keypad sections [001] to [396]
and all messages to the memory key.
To Next Page
Loading...
Need help?
General
