Digiplex LCD Keypad 15n
5.3 PGM Base Time
Section [006]: Option [3]
If the keypad's on-board PGM is set in PGM Timed Mode (see
section 5.2 on page 14) you must define whether the value
programmed in section [008] is in minutes or seconds.
5.4 PGM Override
Section [006]: Option [4]
When the PGM override is enabled, the keypad's on-board PGM
will ignore PGM Activation Events (section 5.6 on page 16), PGM
Deactivation Events (section 5.7 on page 16), and PGM Timers
(section 5.5 on page 15). It will remain in its normal state until the
PGM Override is disabled. This option may be used to test the
PGM connections.
5.5 PGM Timer
Section [008]
If the keypad's on-board PGM is in PGM Timed Mode, the value
programmed in section [008] represents how long the PGM will
remain in its opposite state (see section 5.1 on page 14) after
being activated. To program the timer, enter a 3-digit decimal
value (000 to 255) in section [008]. The 3-digit value will be
multiplied by the PGM Base Time of 1 second or 1 minute (see
section 5.3 above). Default: 5 seconds.
Option [3] OFF = PGM Base Time is 1 second (default)
Option [3] ON = PGM Base Time is 1 minute
Option [4] OFF = PGM Override disabled (default)
Option [4] ON = PGM Override enabled
To Next Page
Loading...
Need help?
General
