12 Reference & Installation Manual
4.11 Beep on Trouble
Section [005]: Options [1] to [4]
Potential troubles have been sorted into groups. With these
options enabled, the keypad will emit an intermittent beep tone
whenever a trouble condition from the Trouble Groups occurs in
the system. The intermittent beep will remain activated until the
user enters the Trouble Display or if the trouble is resolved. For a
list of the troubles, see the DGP-848 or DGP-NE96 Reference
and Installation Manual. The intermittent beep will be re-
initialized whenever the trouble condition re-occurs.
4.12 Keypad Tamper Enable
Section [006]: Option [5]
When tamper is enabled and the keypad's on-board anti-tamper
switch is triggered, the keypad will send a Tamper report to the
control panel via the combus.
O
ption [1] OFF = Beep disabled: System Troubles and Clock
Loss (default)
Option [1] ON = Beep enabled: System Troubles and Clock Loss
Option [2] OFF = Beep disabled: Communicator Troubles (default)
Option [2] ON = Beep enabled: Communicator Troubles
Option [3] OFF = Beep disabled: Module and Bus Troubles
(default)
Option [3] ON = Beep enabled: Module and Bus Troubles
Option [4] OFF = Beep disabled: all Zone Troubles (default)
Option [4] ON = Beep enabled: all Zone Troubles
To Next Page
Loading...
Need help?
General
