Digiplex LCD Keypad 5n
serial number is located on the keypad's PC board or enter
section [000] in Step 3 to view the keypad’s serial number.
3.2 Programming Methods
The following methods can be used when programming the keypad:
3.2.1 Feature Select Programming
Some sections are programmed by enabling or disabling
options. Within the sections, numbers from [1] to [8]
represent a specific keypad option. Press the key
corresponding to the desired option and the digit will appear
in the display. This means the option is enabled. Press the
key again to remove the digit from the display thereby
disabling the option. Press [
ENTER] when options are set.
3.2.2 Decimal Programming
Some sections require that a decimal value be entered. In
this method, any digit from 000 to 255 can be entered.
3.3 Module Broadcast
The control panel’s Module Broadcast feature can be used to
copy the contents of one keypad to one or more keypads.
1. From Normal Mode press and hold the [0] key.
2. Enter [
INSTALLER CODE] (Default: 000000).
3. Enter section [954] (DGP-848) / [4004] (DGP-NE96).
4. Enter the [
SERIAL #] of the source keypad. The source is
the programmed keypad whose data you want to copy to
other keypads.
5. Enter the [
SERIAL #] of the destination keypads. The
destination is the keypad(s) you want to program with the
To Next Page
Loading...
Need help?
General
