8 Reference & Installation Manual
4.0 System Options
4.1 Partition Assignment
Section [001]: Options [1] to [8]
Each keypad in the system can be assigned to one or more
partitions. In section [001], options [1] to [8] represent partitions
1 through 8 respectively. To assign the keypad to a partition,
simply enable the option that corresponds to the desired
partition. By default, partitions 1 to 8 are enabled.
Section [001] options [5] to [8] can only be used if the
keypad is connected to a DGP-NE96 control panel.
4.2 Display Access Code Entry
Section [003]: Option [1]
The digits of the user access codes can be displayed on the LCD
screen when they are entered.
4.3 Display Exit Delay Timer
Section [003]: Option [2]
Based on the user's needs, an Exit Delay Timer will be
programmed to provide the user time to exit the partition before
the system is armed. The Exit Delay Timer's countdown can be
displayed on the LCD screen.
O
ption [1] OFF = Digits are replaced by a * (default)
Option [1] ON = Access Code digits will be displayed
Option [2] OFF= Will not display Exit Delay timer (default)
Option [2] ON= LCD screen will display Exit Delay timer
To Next Page
Loading...
Need help?
General
