Bold = Default Setting
SECTION [134]: Partition 2 Options
Option OFF ON
[1] Auto-Arm on Time l Disabled l Enabled
[2] Auto-Arm on No Movement l Disabled l Enabled
[3] Auto Arming = Regular or Stay l Regular Arming l Stay Arming
[4] Future Use l N/A l N/A
[5] Future Use l N/A l N/A
[6] Future Use l N/A l N/A
[7] Switch to Stay Arming if no entry delay is opened l Disabled l Enabled
[8] Future Use l N/A l N/A
SECTION [135]: Dialer Options
Option OFF ON
[1]
[2]
l see table
l see table
l see table
l see table
[3] Reporting l Disabled l Enabled
[4] Dialing Method l Pulse Dialing l Tone (DTMF) Dialing
[5] Pulse Ratio l 1:2 (Europe) l 1:1.5 (North America)
[6] If armed, activate bell output on Com. Failure l Disabled l Enabled
[7] Future Use l N/A l N/A
[8] Future Use l N/A l N/A
SECTION [136]: Dialer Options
Option OFF ON
[1] Call Back l Disabled l Enabled
[2] Automatic Event Buffer Transmission l Disabled l Enabled
[3] Contact I.D. Report Codes l Programmable l All Codes (automatic)
[4] Alternate Dial l Disabled l Enabled
[5] If no dial tone is present l Continue after 4 sec. l Hang-up after 16 sec.
[6] Future Use l N/A l N/A
[7] Future Use l N/A l N/A
[8] Future Use l N/A l N/A
SECTION [137]: Event Call Direction
Option OFF ON
[1] Call Telephone #1 for Arming/Disarming Report Codes l Disabled l Enabled
[2] Call Telephone #2 for Arming/Disarming Report Codes l Disabled l Enabled
[3] Call Telephone #1 for Alarm/Restore Report Codes l Disabled l Enabled
[4] Call Telephone #2 for Alarm/Restore Report Codes l Disabled l Enabled
[5] Call Telephone #1 for Tamper/Restore Report Codes l Disabled l Enabled
[6] Call Telephone #2 for Tamper/Restore Report Codes l Disabled l Enabled
[7] Future Use l N/A l N/A
[8] Future Use l N/A l N/A
To Next Page
Loading...
Need help?
General
