PARTITIONING
The Spectra system is equipped with a partitioning feature which can divide the alarm system into two distinct areas
identified as Partition 1 and Partition 2. Partitioning can be used in installations where shared security systems are more
practical, such as an office/warehouse building. When partitioned, each zone, each User Code and some of the system's
features can be assigned to either Partition 1, Partition 2, or both partitions. If the system is not partitioned, all User Codes
and features will be recognized as belonging to partition 1.
PROGRAMMING ACCESS CODES
Access Codes are personal identification numbers that allow users to enter certain programming modes, arm or disarm the
alarm system as well as activate or deactivate PGMs. The Spectra security system supports the following:
System Master Code can arm or disarm any partition using any arming method and can create, modify or delete any User
Access Code. Only the System Master Code can modify or delete User Access Codes assigned to both partitions.
Master Code 1 is permanently assigned to partition 1 and can be used to create, modify or delete User Access Codes that
are assigned to partition 1.
Master Code 2 is permanently assigned to partition 2 (except when partitioning is disabled, Master Code 2 will be assigned
to partition 1) and can be used to create, modify or delete User Access Codes that are assigned to the same partition.
45 User Access Codes (including 1 Duress code)
How Do I Program Access Codes?
1) Press [ENTER]
2) Key in the [SYSTEM MASTER CODE] or [MASTER CODE]
3) Key in 3-digit [SECTION] (see Table below)
4) Key in new 4 or 6-digit [ACCESS CODE]
[ENTER] flashes. Return to step 3
How Do I Delete Access Codes?
1) Repeat steps 1 to 3 (see above)
2) Press the [FORCE] button once for each digit in the access code (4 or
6 times) until the keypad emits a "CONFIRMATION BEEP"
Section User Codes
[001] User Code 001 = System Master Code
[002] User Code 002 = Master Code 1
[003] User Code 003 = Master Code 2
[004] to [047] User Code 004 to User Code 047
[048] User Code 048 or Duress Code
How does a partitioned system work?
• Users can only arm/disarm partitions to which they have been
assigned.
• Only zones assigned to Partition 1 will arm/disarm when Partition 1 is
armed or disarmed.
• Only zones assigned to Partition 2 will arm/disarm when Partition 2 is
armed or disarmed.
• Zones assigned to both partitions will arm when both partitions are
armed and will disarm when at least one partition disarms.
• Some of the system’s features can be programmed separately for
each partition.
To Next Page
Loading...
Need help?
General
