Parker 890CD - Appendix A: Using the 6511 Keypad

Page 20
Appendix A: Using the 6511 Keypad
The 6511 is the keypad that comes as standard with any
890 product. It is a one-line backlit LCD with units and
symbols for different functions. It can be used to setup
and configure the 890. It can also be used to operate
the drive in Local mode from its Start and Stop buttons.
From power-up, the keypad displays the Software
Version, and then times-out to show the Remote
Setpoint, as shown opposite.
To change Operating Mode:
On the 890CS you can change between local
and remote mode from any point on the MMI.
However, on the 890CD you must be at the top
of the MMI, showing the software version,
before you can change between local and
remote modes.
Mode Action
Hold the Stop key down
until is displayed
Remote
to
Local
Hold the Stop key
down
until and are
removed
Local
to
Remote
Displays the units for the value:
S for seconds, A for current in Amps, V for voltage in
Volts, % for percentage, Hz for frequency in Hertz
Indicates Local Mode
(Remote Mode when not
visible)
Displays diagnostics, parameter and trip
information
Indicates motor
shaft direction
(890CD), or DC
link enabled
(
890CS
)
To display the software version (890CD):
Press
repeatedly to display software
version.
To Stop in
Local Mode:
Press
To Start in
Local Mode:
Press
To display the line voltage rating (890CS):
As above, then press
or to toggle
between software version and line voltage
rating.
To display the software version (890CS):
Press and hold
to display software version.