Parker ac890 - Page 272

The Keypad
9-28
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
Changing the Product Code (3-button reset)
On rare occasions it may be necessary to change the default settings by changing the Product Code. The
Product Code is detailed in Appendix E.
A special key combination is required to change the product code. This feature is only available at power-
up as a security measure.
The 3-button reset will take you to the POWER BOARD menu in the expanded SYSTEM menu
(highlighted in the diagrams below).
6511 Keypad Combination
IMPORTANT We recommend
the menus marked
* above are only
used by Parker
SSD Drives or
suitably qualified
personnel.
Note The LANGUAGE
menu currently
contains selection
for ENGLISH
only.
Hold down the keys opposite:
-
Power-up the drive, continue
to hold for at least 2 seconds
t
E
HOLD
for example
E
Select from the
expanded SYSTEM menu
see
diagram
below
M
*
*
*