Parker ac890 - Page 282

The Keypad
9-38
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
The Menu System
The unit will initialise in Remote Mode from factory conditions. The Keypad will display the Operator
Menu. Each menu contains parameters.
y
WELCOME SCREEN
SETUP
DIAGNOSTICS
menu at level 1
OPERATOR
menu at level 1
M
menu at level 1
SETUP
menu at level 1
QUICK SETUP
SYSTEM
menu at level 1
Welcome Screen
Displays the software version of the unit
From the Welcome Screen, the display times-out (alternatively
you can press the
key) to show the first of 4 menus:
Operator
A customised view of selected parameters
contained in the SETUP menu. Refer to
Chapter 10.
Diagnostics
A view of important diagnostic parameters
contained in the SETUP menu. Refer to
Chapter 10.
Quick Setup
A quick-setup list of the most commonly
used configuration parameters. Refer to
Chapter 10.
Setup
Contains all the function blocks parameters
for programming your application. Refer to
Appendix D.
System
Application "save" and macro selection.