11-17
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
Trip Groups
The DISABLE WORD, ACTIVE WORD, WARNINGS WORD and TRIGGERS WORD parameters use a
four digit hexadecimal number to identify individual trips. Each trip has a unique corresponding number.
• Refer to Appendix D: TRIPS STATUS for a complete trip listing for DISABLE WORD, ACTIVE
WORD, WARNINGS WORD.
• Refer to Appendix D: AUTO RESTART for information about TRIGGERS WORD.
Automatic Trip Reset (6901 keypad)
Using the Keypad, the drive can be configured to automatically attempt to reset a trip when an attempt is
made to start driving the motor, or after a preset time once the trip condition has occurred. The following
function blocks (MMI menus) are used to enable automatic trip resets.
Seq & Ref::Auto Restart (Auto-Reset)
Seq & Ref::Sequencing Logic
Setting Trip Conditions (6901 keypad)
The following function blocks (MMI menus) are used to set trip conditions:
Trips::I/O Trips
Trips::Trips Status
To Next Page
Loading...
